$ cat /notes/poe-standards-cheat-sheet
PoE Standards Cheat Sheet
A quick comparison of passive PoE, 802.3af, 802.3at, and 802.3bt power levels, types, powered pairs, and device-side wattage.
Power over Ethernet terminology becomes confusing quickly because the same product pages may use PoE, PoE+, PoE++, 4PPoE, wattage, or IEEE type numbers.
This is the short version I keep handy.
| Specification | Passive PoE | PoE | PoE+ | PoE++ Type 3 | PoE++ Type 4 |
|---|---|---|---|---|---|
| IEEE standard | Proprietary | 802.3af | 802.3at | 802.3bt | 802.3bt |
| PoE type | None | Type 1 | Type 2 | Type 3 | Type 4 |
| Maximum PSE power | Varies | 15.4 W | 30 W | 60 W | 90 W |
| Maximum power at PD | Varies | 12.95 W | 25.5 W | 51 W | 71.3 W |
| Pairs used | Varies | 2 pairs | 2 pairs | 2 or 4 pairs | 4 pairs |
| Typical voltage | Often 24 V or 48 V | 44–57 V | 50–57 V | 50–57 V | 52–57 V |
PSE means Power Sourcing Equipment: normally a PoE switch or injector.
PD means Powered Device: the access point, camera, VoIP phone, sensor, or other device receiving power.
The PSE number is higher because some power is lost in the cable. For example, an 802.3at switch port may advertise 30 W, but the standard guarantees 25.5 W at the powered device.
Passive PoE Is Different
Passive PoE is not an IEEE PoE type.
A passive injector may place a fixed voltage on selected cable pairs without the detection and classification process used by standards-based PoE. Voltage, polarity, pin assignment, and device compatibility must all be verified before connecting equipment.
Standards-based PoE asks whether the device wants power.
Passive PoE may skip the introductions and proceed directly to the smoke test.
Don’t Forget the Switch Power Budget
A switch may support a particular PoE standard on every port without having enough total power to run every port at its maximum simultaneously.
Check both:
- The maximum power available on an individual port.
- The switch’s total PoE power budget.
A 24-port PoE+ switch does not necessarily have 720 watts available merely because 24 × 30 equals 720 and arithmetic is feeling optimistic.
Quick Selection Guide
- 802.3af / Type 1: basic VoIP phones, simple cameras, and lower-power devices.
- 802.3at / Type 2: many wireless access points, PTZ cameras, and higher-power endpoints.
- 802.3bt / Type 3: multi-radio access points, larger cameras, displays, and other devices requiring more than PoE+.
- 802.3bt / Type 4: the highest-power standards-based devices, up to about 71.3 W available at the PD.
Always size from the device requirement, not just the marketing label printed on the switch.